Installation

NYTRON Setup Guide

Install your motorcycle light kit cleanly, safely, and correctly.

Download App Start Setup Troubleshooting

Read the full guide before connecting the kit to your battery.

01 · Unboxing

What's in the box

  • NYTRON controller
  • 8 waterproof LED strips
  • Strip connectors
  • Inline switch
  • Inline fuse
  • Battery connectors
  • 3M mounting tape
  • Controller mounting pad
  • Installation tool
  • Quick start guide

02 · Pre-flight

Before you start

Read this first

  • Turn the motorcycle off.
  • Keep the inline switch OFF.
  • Do not connect the battery wires yet.
  • Test the full kit before final mounting.
  • Do not install strips near exhaust, engine heat, chain, tires, suspension, or sharp edges.
  • Clean every mounting surface before applying tape.

03 · Installation

Step-by-step setup

  1. Plan the strip locations

    Place the strips around the motorcycle before peeling any tape. Use longer strips for larger visible areas and shorter strips for tighter areas. Make sure all cables can reach the controller cleanly.

  2. Connect the strips first

    Plug all 8 strips into the strip connectors. The controller has 2 output branches, and each branch supports 4 strips. Push every waterproof connector fully together.

  3. Test before mounting

    Connect the red wire to battery positive and the black wire to battery negative. Turn the switch ON and test the lights before final mounting.

  4. Download and connect the app

    Download our app using the link above, turn the kit on, and connect to the controller.

  5. Clean and mount the strips

    Turn the kit OFF first. Clean each spot. Make sure it's dry.

    Peel the backing, press each strip firmly for 20 to 30 seconds. The adhesive won't damage your bike :)

    Tip: You can also tuck the strips inside your fairings instead.

  6. Mount the controller

    Choose a hidden and protected location. Keep the controller away from direct engine heat and areas where water can pool. Use the controller mounting pad and keep the wiring neat.

  7. Final check

    Turn the kit on and check that all strips light up, colors change correctly, the app connects, and all cables are secured away from hot or moving parts.

04 · Common issues

Troubleshooting

Check the battery connection, inline switch, fuse, and connectors.
Check that each waterproof connector is fully pushed in.
Turn the kit off and on, keep phone Bluetooth on, then reopen the app.
Check for loose connectors, weak battery connection, or damaged wiring.
The surface may be dirty, wet, oily, or too cold. Clean and dry the surface before mounting.

Safety & waterproof

NYTRON is designed for normal motorcycle outdoor use, including rain and road spray. Do not submerge the controller, connectors, or strips. Avoid pressure washing directly onto electrical parts.

The kit should be installed away from engine heat, exhaust heat, moving parts, sharp edges, tires, chain, and suspension travel.

Community

Show us your build

Post your motorcycle with NYTRON installed and tag us. Top 3 posts each month win a free kit.

@nytronlights

Need help?

Send us a photo or short video of your installation issue. For fastest help, include:

  • Photo of the controller
  • Photo of the battery connection
  • Photo of the strip connectors
  • Short video showing the issue
Contact Support